I am preparing to install a Loksound 5.0 decoder #58821 and will be "hard-wiring" it since the engine has no motherboard (replacing a 3.5 micro). Do I need to use resistors for the LED headlights, as in other "hard wire" installations? Thanks for any help. Here's a 5 step-by-step guide on installing Morimoto resistors to eliminate hyper flash: Expose the wires: Locate your turn signal bulb and cut back the sheathing on the two connected wires. You don't need a lot exposed, just enough to work with. Attach T-taps: Using the T-taps included with the Morimoto resistors, attach one to the power wire
I had to change my front turns signals at the last minute, because my old ones wouldn't fit my new fender flares. I haven't researched these issues at all, and I'm busy working in the rain trying to get my lift finished. I'm being lazy and just asking what is probably a redundant question. I
2009 - 2014 Ford F150 - LEDs - Do Not Install Load Resistors for Hyperflashing! - I am not sure if this is posted here anywhere or not so I will post. (Mods feel free to merge or remove its this is a dupe.) I recently went down the road a full LED conversion on my 2011 F150 XLT. From the get go I was against the idea
USA Located: Alla Lighting Inc's headquarter is located in Chino, CA 91710, USA since 2015, sub-branch at Dallas TX 75081, USA. Alla Lighting, short for Advanced LED Lighting for Automotive Lighting, is specialized in developing new products in auto LED lighting, pioneer in LED headlights, fog lights, turn signal, brake tail, reverse, side marker, license lights, exterior and interior lights
Diode Dynamics Backup Light LED Bulbs. More light output makes reversing at night easier and safer! Our 921-size XP50 LED Backup Light Bulbs are one of the best plug-and-play upgrades you can get for your 2015-2019 GMC Canyon. At 410 lab-verified lumens each, the XP50 produces dramatically more light than the Canyon’s outdated factory reverse wCw1. 109 17 187 21 94 115 65 160 397

do i need resistors for led headlights